How do I read in split QR codes in edit mode?

I'm reading split QR codes in the default edit mode. The beeper sounds, indicating that the read operation is complete, but nothing displays on the screen.

When reading a series of QR codes in edit mode, do not release the trigger switch on the unit until all split QR codes have been read. Prematurely releasing the trigger switch discards all data up to that point, forcing you to start over.

Reading a normal code produces a single pip from the beeper after reading. Reading a series of QR codes, however, produces two pips for the first and the normal single pip for subsequent codes. Reading the final code produces three pips from the beeper and displays (or sends) the data.

Contact us


If you have not registered

The services on this member site are available only for registered customers.

New member reg.