How to download and use BHT Term Emulator software

You can download the BHT Term Emulator from DENSO WAVE’s website in following steps.


  1. You need to make your account of our QBdirect online service to use the BHT Term Emulator. Please register yourself on the QBdirect User Registration page.
    If you have already purchased the license of BHT Term Emulator, please register the product serial number printed on the License Paper, while on the QBdirect User Registration.


  2. QBdirect User Registration:https://www.denso-wave.com/qbdirect/en/member/entry/select_type.html.php

  3. First, you need to log in QBdirect and access the Download page (Viewing this Download page requires your logged-in status). Then, download the "BHT Term Emulator (trial version)" from the download section.

    QBdirect Download:https://www.denso-wave.com/qbdirect/en/member/category/index.php?_mode=detail&detail_file_name=qb%2Fen%2Fdownload%2FBHT_Term_emu.html

  4. To install the program in your PC, uncompress the downloaded file and then execute the installer for the BHT Term Emulator.

  5. You need to configure the appropriate operating environments (host IP address, terminal type, etc) according to the User's Manual installed on your PC. After that, download component files of BHT Term Emulator to the BHT by their installer program.

  6. Execute the downloaded BHT Term Emulator. After the product logo is displayed, the message telling you that the product key is not yet registered, is displayed. If you want to try all the available functions, please select [C = Demo]. Note that, however, you are allowed to use the emulator for only 20 minutes for a single session, as the time the BHT is connected to the host is limited to 20 minutes.


  7. The license registration is required to officially use the BHT Term Emulator. If you have purchased the license of BHT Term Emulator, you have to proceed to the following procedure to apply for the license.


  8. Execute the downloaded BHT Term Emulator. After the product logo is displayed, the message telling you that the product key is not yet registered (see Step 5). Here, if your product is either the BHT-7500W or the BHT-300BW/BWB/QW/QWB, you can check the ID number of your product. For other BHTs, please select [ENT = Registration] to enter the License Registration page and then check the ID number of your product.

  9. Go to the Product Key Issue page and apply for a product key using the product ID and the access code printed on the License Paper.

    Product Key Issue page: https://www.denso-wave.com/prokey/en/

  10. After you get a product key for the BHT Term Emulator, please register the product key on the above Lisense Registration page.