Connect AT20Q-SM to the USB port of the PC on which Active USB-COM Port Driver is not installed, and press the Trigger Switch for two seconds or longer. The interface of AT20Q-SM will be switched to the USB keyboard.
This function is effective when the USB Keyboard Interface Auto-Switching Function has been set to “Enable.”
If the driver has been installed on the PC, the above operation does not switch the interface to the USB keyboard.
This function is effective on the following models.
Model | Firmware Version |
AT20Q-SM/AT21Q-SM | Version 1.10 or later |
AT25Q-SM/AT26Q-SM | Version 1.10 or later |
If you have not registered
The services on this member site are available only for registered customers.